Flipping and Pitching

FLIPPING AND PITCHING ARE KEYS TO BIG BASS


There are many fishing techniques used to catch big bass. Most anglers, if asked, would have an opinion on the most effective ways of taking big bass on a consistent basis. Most professional anglers would agree the most productive means of catching big bass is to use the flipping and pitching techniques.

While both flipping and pitching are great ways to fish, pitching is the most efficient because you can cover water faster. Tournament pro Tom Biffle prefers pitching because he can not only cover more water, he can make longer casts which results in less chance of spooking the fish.

Biffle uses a Quantum seven and one half foot rod with a high speed Quantum reel for most of his pitching. At times he will use a slower reel for the added power necessary to pull big fish from heavy cover. His reel is spooled with clear line in 25-30 pound test. Biffle seldom loses fish because he uses a long rod, heavy line, and ties the Palomar knot.

The rubber-skirted jig is the most popular bait for flipping and pitching. It is usually rigged with a plastic crawfish or pork frog. Traditionally the pork frog has been used for cold water condition and the plastic crawfish for warm water. This is beginning to change among anglers. Biffle says, "I have caught a lot of bass using a plastic crawdad trailer in cold water." He prefers the crawdad because it doesn't turn on the hook and cover the point like the pork frog sometimes does. Many fish have been lost due to this problem. Also, he prefers compact baits because it penetrates the cover better than large bulky bait.

When flipping and pitching with a plastic worm, I recommend using a paddle tail worm. They will fall through heavy cover better. Ribbon tail worms are the worst choice for heavy cover because the tail will wrap around a small limb or weeds and hang up. They are easy to shake free but will not fall at the intended target when you shake them loose.

After you choose your target make your presentation to the thickest part of the cover. Do not start at the outside edges and work your way into the heavy area. Biffle says when bass are holding on buck brush and brush piles the big fish will always be in the middle of the cover. When fishing heavy cover you can use the limbs to your advantage by hanging your bait over one to get a vertical presentation. This allows you to slowly move the bait keeping it in the strike zone longer.

Finding the fish is most of the battle of fishing. Once located, you can try different presentations to confirm the most effective. When looking for fish in the heavy cover you should first consider water temperature. In the spring and summer when the water is warm I look to the back of the coves and creeks with heavy cover. According to Biffle, the buck brush holds more fish in the spring when the bass are spawning. In the summer the willow trees are more productive. During late fall through early winter concentrate on points close to deep water. When fishing points concentrate on areas of the points where submerged brush piles are present. You will find the brush piles will concentrate bass and will greatly increase your success.

While fishing heavy cover treat each piece as a miniature lake, by doing so you can create a pattern within a pattern. After finding the primary pattern, (type of cover, depth, area of lake or river, etc.) I concentrate on what I was doing when a fish was caught. This involves paying close attention to things as whether the fish was taken on the outside or middle of cover; near a small point or cut in the cover; was I using a vertical presentation with aid of a limb, etc... These little differences can make the difference between success and failure.

If you have trouble with backlashes while pitching you are probably loading (flexing the rod by pulling the line tight) when holding the bait. What you should be doing instead is holding the bait in your hand and lifting the rod while releasing the bait. This will cause a pendulum effect and allow for longer and more precise casts. The faster you raise the rod tip the longer the cast will be. At the moment the bait passes over the target you should lift the rod tip while thumbing the spool to a stop. This causes the bait to stop and fall vertically for a quiet entry.

There are a few common mistakes anglers should avoid when flipping and pitching. Flipping requires the angler to be close to the target and in clear water conditions the result is often spooked fish. Pitching allows you to make longer casts to avoid this problem. With both techniques the goal is to have the bait enter the water quietly. A low trajectory on the cast will provide a quiet entry. Also, while flipping, many anglers are still holding the line after the cast is made. Since most bites will occur on the initial fall, by holding the line they leave themselves in a position where a good hook set is impossible.

During seminars Biffle stresses the importance of learning to flip with your less dominate hand. He says since most of the strikes occur on the fall a right handed person will be changing hands to crank the reel when the fish picks up the bait. By learning to pitch and flip with the less dominate hand you will become much more successful.

Next time you are on the water try flipping and pitching for big bass. They are slower than many other techniques but day in and day out they will consistently produce big bass.


Copyright 2008, Marc Rogers
http://www.midwestfishingtackle.net/